Introduction
Hair Loss Treatments
Theatre Setup
Infection Control And Decontamination
Patient Journey
Medication
Surgical Complications
Injection Treatments
Fire Safety
Sepsis
Equality And Diversity
Anaesthetic
The 3 stages of Anaesthetic
- Lidocaine
- This is made up by preparing 2 small petri dishes each containing the 10ml solution. 1 for the donor area and 1 for the recipient. Each Lidocaine 2% ampoules contains 2ml of solution. Put 10ml (2 ampoules) into the petridish and mix with 10ml of isotonic normal saline. This gives a ratio of 1:1 , lidocaine: saline. Although one can use 7mg/kg maximally [when it is mixed with adrenaline]
- The solutions made up is then used to inject with G30 (yellow) needles initially around the borders of the donor site as marked. It is important to pull back the needle ensuring that the needle is not in a capillary/vein before injecting to bleb the skin. Once completed, work your way deeper into the donor area until all is covered, checking the pain levels with the patient each time. It is important to ensure the patient understands it is uncomfortable [burning sensation & pulling sensation while injecting]. The areas retro-auricular [behind the ears] and the occipital border of the marked donor site are of higher sensitivity, so make the patient aware of this and proceed as per the patients tolerability restricting yourself to 2 injections at a times if necessary.
- Bupivicaine
- Preparation – Prepare two small / medium petri dishes for donor and recipient areas. Mix the Bupivicaine 20ml with ¼ ampoule or 0.25 mg adrenaline ampoules, mix all with 10ms of normal saline.
- Application. Similar fashion to previously it is injected with G26 or G27 (brown) needles. Ensuring the bupivacaine has anaesthetised the skin, this provides longer lasting anaesthesia, start at the borders and work your way in until the donor area is completing covered [one injection every 1-2 cm]. Patient should be made aware they may feel tugging or pressure but they should not feel any pain and to alert you if they do.
- Tumescence solution
- Preparation – Place in one petri dish 100ml of normal saline combined with ½ ampoule or 0.5mg of adrenaline.
- Inject using brown needle G26 or G27 injecting in parallel to the scalp to infiltrate the subcutaneous layer.